http://www.cumminsforum.com Feed-merging three firstgen forums into one. en-us http://www.cumminsforum.com/forum/89-93-powertrain/469093-brake-booster.html looking for someone that has put hyd. brake booster on 1992 w250 cummins http://www.cumminsforum.com/forum/89-93-non-powertrain/469060-factory-cat-1993-w350.html Did the cummins come with a catalytic converter in 1993. http://www.cumminsforum.com/forum/89-93-performance-parts-discussion/469023-hx-35-exhaust.html i mounted my hx 35...come out of a 99 manual it has the cast elbow witht he 5 bolts my question is what are you guys doing to mate the 2nd gen dowpipe to a 1stgen exhaust. im looking to get a 4inch exhaust but looks like a 4inch down pipe might be tight. but after that im curious if you guys are... http://www.cumminsforum.com/forum/89-93-powertrain/469022-air-intake-interchangability.html What air intakes fit our manifolds? I think 2nd gen without the front brace, any thing else, with a 3 " intercooler hose size? http://www.cumminsforum.com/forum/89-93-performance-parts-discussion/469016-manifold-help-quick-24v-manifold-12v.html I can get a like new ats 3 piece manifold off a 99 24v for very cheap but will it bolt up? Are they the same http://www.cumminsforum.com/forum/89-93-performance-parts-discussion/469013-i-love-my-truck-fuel-pin-installed.html I figure nobody cares, but I have an old 92 W250 automatic. It's a little rusty, the front fenders are sagging a tad, and the factory clear coat is fading off her red facade..... I had to make a TPS (thanks guys!), and had to put on a pull out shut down cable. I installed an M3 fuel pin today... http://www.cumminsforum.com/forum/89-93-performance-parts-discussion/468989-fuel-pump-air-ride.html I am sticking a cummins in a 66 f100 with an air ride. The fuel cell is located behind the frame notch which is rather large and the fuel lines will have to follow the frame uphill quite a ways and go back down before heading to the motor. Would this be a problem for the stock mechanical pump or... http://www.cumminsforum.com/forum/89-93-non-powertrain/468978-goose-neck-hitch.html Ok so need to put a goose neck hitch in the truck. My question is this. How are yall doing it? There is no space between the bed and the frame. I called one company that does it locally and it is gonna be 450 for a standard non flip down ball. Thought that was a bit HI!!! http://www.cumminsforum.com/forum/89-93-performance-parts-discussion/468974-hydro-brake-booster.html has any one out there put a hydra. brake booster on a 1992 w250 with Cummings i have heard of it being done http://www.cumminsforum.com/forum/89-93-powertrain/468943-clutch-advice.html Any recommendations on a clutch brand? Decided that since the transmission is out for the rear main seal, might as well as replace the clutch. THanks in advance.